Extra large titanium–ceramic plates fordeep, frizz&nd ash;free waves
Ultra–advanced ceramic heaters give 15second heat up with constant, regulatedtemperature control
5 digital temperature settings up to 210?C
Stay cool safety tip
Salon length 2.7m swivel cord for easeof use
Heat mat with storage compartment forconvenience and safety
Ensure hair is dry and combed through.
Press the I/0 button to switch the styler on.
Use the temperature +/ buttons to select the preferred temperature. The temperature increases in 10°C increments for specific temperature control (170°C 210°C).NOTE: Always start with a lower temperature and increased gradually if required.
The appliance will almost instantly heat up to the chosen heat setting
Divide dry hair into 4cm sections and comb through.
Take a section of hair, starting around 3 4 inches from the scalp.
Place the hair section between the top and bottom plates of the styler. The top plate of the styler should face away from your head (the flat base plate will protect your face).
Clamp the handles together until they close and hold in place for 5 8 seconds. Take care to avoid the hot surfaces of the styler coming into contact with the skin, in particular the eyes, ears, face and neck.
Release the handles, gently move the styler down the section and re position to overlap the last wave created, to ensure a continuous wave effect in the hair.
Continue down the entire hair section, towards the ends of the hair.
Repeat as necessary.
After use, press the I/0 button to turn the styler off and unplug.
Allow the styler to cool completely before storing away. For extra protection, wrap the styler in the heat protection mat.